pool depth
英 [puːl depθ]
美 [puːl depθ]
网络 余铁深度; 熔池深度
双语例句
- And the effect of SPreading fusion of active flux on weld pool depth and arc phenomenon in A-TIG welding is also studied with properly experimental method.
采取适当的试验方法研究A－TIG焊活性剂对电弧现象及活性剂涂敷量对焊接熔深增加的作用。 - The swimming pool is3 metres at its greatest depth.
游泳池最深处为3米。 - There were three types of the oil and gas accumulation model: Primary pool near to depression, Adjustment pool controlled by source rock and fault, and Secondary pool with shallow depth.
综合分析文留油气藏的成藏模式主要有三种类型，及近洼自生型、油源断层控制的调整型、与浅层次生型。 - Effect of ESR remelting parameters on pool depth
调整工艺参数对ESR熔池深度影响的研究 - The result shows that the diameter of plasma arc beam becomes smaller, the stiffness and the stability increase and arc starting is easier, the pool depth of the deposition layer increases and the pool width decreases after laser acts on plasma arc.
试验结果表明：激光作用于等离子弧后，等离子弧柱的直径变小，挺度增加，稳定性增强，起弧容易，熔积层的熔深增大，熔宽减小。 - Numerical simulation study on heat and mass transfer process and the use of CFD technology to the molten pool smelting blowing stirring, to investigate the effect of injection speed, depth of the bath flow and bath splash damage to the furnace wall is very necessary.
因此利用CFD技术对熔池熔炼喷吹搅拌的传热传质过程进行数值模拟研究，探讨喷吹速度、深度对熔池内流型的影响以及熔池喷溅对炉壁的破坏作用是十分必要的。 - Based on the form, energy dissipation characteristic of suspended grid plunge pool, the change of water depth of plunge pool and swell in downstream before and after putting suspended grid are further analyzed in this paper.
通过试验研究，进一步分析悬栅消力池的消能特性，加栅前后消力池内水深及消力池下游明流洞内涌浪的变化。 - Add metal from the rod by dipping the end into the pool so that it melts and makes up the vee. The waterlogging depth has significant effects on the growth and morphological structure of Taxodium ascendens.
将焊条一端浸入池内熔化，填满V形坡口。浸水对池杉的生长及其形态结构影响很大。 - Effect of VaR remelting parameters on pool depth
调整工艺参数对真空自耗重熔锭熔池深度影响的研究 - On the basis of above results, the mutual relationships among temperature, molten pool depth, mass transfer distance, parameters of the laser and properties of materials were carefully discussed.
根据计算结果，分析了温度、熔覆深度、界面传质过程与激光参数、材料性质及时间的关系。